Indoor Pan/Tilt Head AW-PH400
Installation
$ Attaching the wire
The wire is not provided. Use one which is strong enough to bear the weight of the whole camera (camera + lens).
When mounting the cameras with fan (AW-E655, AW-E750, AW-E800, AW-E800A)
1 Use the wire mounting screw (M4!8 mm with flat washer and spring washer) to attach one end of the wire to the pan/tilt
head's arm.
2 Mount the mounting spacer on the top panel of the camera.
3 Use the wire mounting screw (M4!6 mm with flat washer and spring washer) to attach the other end of the wire to the screw
hole of the mounting spacer.
When mounting the cameras without fan (AW-E350, AW-E650, AW-E300, AW-E300A, AW-E600)
1 Use the wire mounting screw (M4!8 mm with flat washer and spring washer) to attach one end of the wire to the pan/tilt
head's arm.
2 Use the wire mounting screw (M4!6 mm with flat washer and spring washer) to attach the other end of the wire to the screw
hole of the top panel of the camera.
For a stand-alone installation
≥ Camera: AW-E750
M4!6 mm wire
mounting screw
with flat washer
and spring washer
Mounting
spacer
(supplied with
AW-E750)
≥ Camera: AW-E650, AW-E350
Be absolutely sure to tighten up the mounting spacer and screws securely using a tool such as a screwdriver.
(Be sure to ask your dealer to install the unit.)
Arm
Wire
M4!8 mm wire
mounting screw
with flat washer
and spring washer
For installation on the ceiling
≥ Camera: AW-E750
≥ Camera: AW-E650, AW-E350
18
M4!8 mm wire mounting
screw with flat washer and
spring washer
M4!6 mm wire mounting
screw with flat washer and
spring washer
Mounting spacer
(supplied with
AW-E750)