Mounting The Camera (Mulit-Purpose Camera Ak-Hc1500G) - Panasonic AW-PH405N Operating Instructions Manual

Installation
 Mounting the camera
[Multi-purpose camera AK-HC1500G
When mounting the camera, take sufficient care to ensure that the camera will not come off or fall down.
 Mount the lens onto the multi-purpose camera.
(1) Lenses that can be used
• Use any of the portable lenses which are listed below.
Fujinon
Canon
(2) Lenses that cannot be used
• Do not use the large-sized lenses [with a weight of 11 lbs (5 kg) or more
and a length of 15-/4" (400 mm) or more] with the model numbers
which are listed below since when they are mounted on the camera,
the camera's overall balance will be upset.
Fujinon
Canon
 Align the multi-purpose camera with the guide pins and mount it.
Change the positions of the guide pins and screws of the camera mounting base as shown in the figure below, and then
attach the camera mounting base to the rotary arm.
 Do not use the rubber piece.
For a stand-alone installation
Camera Mounting base
Change the positions of the camera mounting
screws. (Change them over to the second row.)
 Tighten up the two mounting screws securely using the tool.
For installation on the ceiling
Camera Mounting base
Change the positions of the camera mounting
screws. (Change them over to the third row.)
 Just as for a convertible camera, change the positions of the guide pins and screws of the camera mounting base as shown
in the figure above, and then attach the camera mounting base to the rotary arm.
]
HA18, HA1, HA series
HJ17e, HJ1e series
HA4 series
HJ40 series, J5 series
Change the positions
of the guide pins.
Change the positions
of the guide pins.
Note
Set the guide pin.
Mount the camera
with the mounting
screws.
Mounting screws
0
 The current rating of LENS
I/F () connector is 500 mA
(max).
Even with the lenses in a
series which can be used,
any lens whose maximum
current consumption
exceeds 500 mA cannot be
used.
Concerning the maximum
current consumption of
the lens, contact the lens
manufacturer.
Set the guide pin.
Mount the camera with
the mounting screws.
Mounting screws