Table of Contents
Advertisement
Outline
≥ This unit is a camera controller for multi-purpose camera (AK-HC900P). This
unit is connected to a multi-purpose camera with one multi-cable, and capable
of transmitting and receiving various camera and lens control signals, analog
picture signals of cameras, and generator lock signals (3-value SYNC).
≥ The extension distance between this unit and the camera is 33 ft (10m) max.
≥ It is possible to control the swivel stand from the pan-tilt control panel AW-
RP301 by using the swivel stand control input connector.
Check the Accessories
Coupling . . . . . . . . . . . . . . . . . . . . . . .1 pc
Multi-cable . . . . . . . . . . . . . . . . . . . . . .1 pc
Seal . . . . . . . . . . . . . . . . . . . . . . . . . . .1 pc
Precautions for Use
≥ We recommend that the AC adapter AW-PS505P is used for power supply.
≥ Handle the unit with care.
If dropped or given a strong shock, it may cause a trouble or accident.
≥ Use the unit in a temperature range of 32oF to 104oF (0oC to + 40oC).
If used at a temperature below 32oF or higher than 104oF, it may cause bad influences to
the component parts.
≥ Turn off the power before connecting or disconnecting the cable.
When connecting or disconnecting the cable, be sure to turn off the power switch of the
unit beforehand.
≥ Avoid using the unit outdoors.
≥ Install the unit 3.3 ft (1 m) away from the monitor.
≥ Maintenance
Pull out the power cord plug and clean the unit with dry cloth. If it is hard to clean,
moisten the cloth with a diluted neutral detergent solution and squeeze it well and lightly
wipe the unit.
Precautions
≥ Do not use volatile solvents such as benzene or thinner.
≥ When using a chemical mop, carefully read the instructions.
4
Setscrews . . . . . . . . . . . . . . . . . . . . .8 pcs
M4 x 8 mm . . . . . . . .4 pcs
M5 x 8 mm . . . . . . . .4 pcs
Advertisement
Table of Contents
