Table of Contents
Advertisement
3.
Use remote access software to set login parameters as shown in
Table 11 Default login parameters
Parameter
Protocol
Port number
Management IP address of the OM
Username and password for logging in to the OM
•
SSH access is enabled by default.
•
The data in the table is only an example. Configure the parameters as needed.
The following information is displayed after login:
******************************************************************************
* Copyright (c) 2004-2019 New H3C Technologies Co., Ltd. All rights reserved.*
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<OM>
Collecting logs
1.
Log in to the operating system of the device where the subnet manager is installed. For more
information about subnet managers, see "Prerequisites" in H3C UniServer BX1020B IB Switch
Module Configuration Guide.
2.
Execute the
command to generate a log file.
name>
Figure 10 Generating a log file
mlxdump -d <IB device> snapshot --mode full -o <log name>
represents the log file name. The file name must be suffixed with .log.
Description
SSH
22
•
•
•
•
represents the switch module name, and
<IB device>
3
Table
11.
IP address: 192.168.100.100
Subnet mask: 255.255.255.0
Username: admin
Password: Password@_
*
*
<log
Advertisement
Table of Contents
