Erasing Tracks - Aiwa CSD-MD5 Operating Instructions Manual

ERASING TRACKS

ERASING ALL THE TRACKS ON A DISC
2
CANCEL
1
Press MD e to select MD function and insert
an MD.
2
Press ERASE in stop mode.
"ALL Erase ?" is displayed for 10 seconds.
3
Within 10 seconds, press ENTER.
Make sure to check that it is all right to erase all the
tracks.
To cancel, press CANCEL.
4
Within 1 minute, press ENTER again.
All the tracks on the inserted disc are erased.
TOC EDIT is displayed and the data concerning the
contents of the editing are registered.
NOTE
• While TOC EDIT is displayed, do not disconnect the AC
cord or shake the unit. Otherwise, the TOC data is not
registered properly.
• A disc cannot be edited:
- when a prerecorded disc is inserted. ("PB Disc" is
displayed.)
- when the record-protect tab on an inserted disc is moved
to the protected position. ("Protected" is displayed.)
- during programmed play.
ERASING ONLY ONE TRACK
1
2
1
3, 4
CANCEL
1
Press MD e to select MD function and insert
an MD.
2
Select the track with JOG DIAL or the numbered
buttons. Then press ERASE.
"Track Erase?" is displayed for 10 seconds.
3
Within 10 seconds, press ENTER.
Make sure to check that it is all right to erase the track.
To cancel, press CANCEL.
4
Within 1 minute, press ENTER again.
The selected track is erased and all the succeeding track
numbers also move down by one.
When TOC EDIT is displayed, the data concerning the
contents of the editing are registered.
1
1
2
3, 4
2
En
E
F
21
ENGLISH