– Separate speed sensor and speed sensor wiring connector
-1-.
– Remove bolt -2- from wheel bearing housing.
– Remove ABS speed sensor from wheel bearing housing.
Installing
– Before inserting wheel speed sensor, clean inner surface of
bore hole and coat sensor completely with Polycarbamide
Grease - G 052 142 A2- .
– Insert the speed sensor into the hole in the wheel bearing
housing and tighten the bolt to 8 Nm.
– Connect the speed sensor to speed sensor wiring.
5.3
Rear Axle, Overview
1 - ABS Wheel Speed Sensor
❑ Before inserting sensor,
clean inner surface of
bore hole and coat with
Polycarbamide Grease
- G 052 142 A2- .
❑ Removing and Instal‐
ling. Refer to
⇒ "5.4 Speed Sensor on
Rear Axle, Removing
and Installing",
page 39
.
2 - Hex Socket Bolt
❑ 8 Nm
3 - Wheel Bearing/Hub Unit
❑ The ABS sensor ring is
installed in the wheel
bearing.
4 - Drive Axle
5.4
Speed Sensor on Rear Axle, Removing
and Installing
Removing
– Raise the vehicle.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
Brake System - Edition 03.2018
5. ABS Components on Front and Rear Axles
39