Table of Contents
Advertisement
periods of sleeping.
• It is dangerous to use this reclined cradle on an
elevated surface, e.g. a table.
Instructions for use
1• "Primo Viaggio SL" is provided with the Ganciomatic
System for attachment to/detachment from an "Isofix
Base" or "Belted Base" in the vehicle and Peg-Perego
strollers and chassis outside the vehicle.
To install "Primo Viaggio SL" (on an "Isofix Base", "Belted
Base", or Peg-Perego stroller or chassis) align it with the
attachment points and push down until it clicks into
place.
2• To release "Primo Viaggio SL" (from an "Isofix Base",
"Belted Base", or Peg-Perego stroller or chassis) raise the
handlebar to the transport position, push the lever on
the backrest upwards and at the same time raise the car
seat.
3• To engage the harness, place the two shoulder strap
tongues in position and insert them into the buckle
of the crotch strap until they click into place (fig. a). To
release the harness, press the red button on the crotch
strap buckle (fig. b) and remove the straps.
4• To slacken the harness, insert a finger through the seat
opening (fig. a), keep the metal button pressed, and with
the other hand pull on the straps (fig. b).
To tighten the straps until they are snug to the child's
body, pull the central adjustment strap towards you (fig. c).
CAUTION: Do not over-tighten the straps, and
ensure you leave minimum slack.
5• The harness and the "Side Impact Protection" headrest
can be adjusted simultaneously to 5 different heights so
as to follow the growth of the child.
To adjust the height, press the rear height adjustment
button (on the car seat backrest) and at the same time
raise or lower the straps and headrest to the required
position, ensuring that they click into place. Slacken
the shoulder straps before adjusting the height of the
harness and headrest.
6• Adjust the height of the headrest so that the straps are
just below the child's shoulders.
7• The seat is equipped with an anatomic booster cushion
for newborns, to be removed when the child is older.
8• The car seat handlebar has four fixed positions. To
rotate it, press the two buttons on the handlebar and
move this to the required angle. Ensure it clicks into
position.
• Position A: the in-vehicle position;
• Position B: the position for transport by hand and for
installation on a base, stroller or chassis;
• Position C: allows the car seat to rock;
• Position D: stops the car seat from rocking;
9• To fit the hood, insert the hood attachments into the
openings on the car seat and arrange the rear part of
the hood behind the backrest.
Finally, fasten the elastic bands behind the handlebar.
10• The hood has two possible positions, opened or closed.
To remove the hood: release the elastic bands behind
the handle, lift the hood and remove it upwards.
•
IMPORTANT: The hood must not be used to lift
the car seat because it might detach.
Instructions for in-vehicle use
11• Fit the car seat with the child seated inside,
Advertisement
Table of Contents
