Controllers Recorder Tab - Panasonic WJ-MPU955A User Manual

More than one mode can be programmed at the same time by clicking on
the Prog check boxes of the other mode numbers that you wish to
program simultaneously. This will append, or add any permissions that
are then changed on the permissions grid, but will not duplicate entire
modes or overwrite existing permissions in the other modes.
The image to the left indicates that the permissions grid would now be
displaying the contents of mode 3 (which is also by default being
programmed), and would simultaneously be programming any subsequent
changes into modes 1 and 4 as well.
It is not necessary to perform a Save for each mode viewed or programmed. Saving
permissions, when completed, automatically saves all four modes, regardless of the
current View or Prog selection.

Controllers Recorder Tab

The Recorder permission tab on the Controller window allows an administrator to specify
which recorders can be seized by the selected controller. It shows permissions from the
controller's point of view.
By default, all components are allowed to access all other components. An administrator
must deny permissions.
1. Click on the Recorder permission tab from the Controllers window
Allowing a system controller to control a certain recorder will automatically
allow the same controller to view video from the specified recorder.
Controllers are displayed in the list on the left by ID number, but can also be viewed by
IP address (IPA), Ethernet address (EA), or area. The grid on the right represents the
following:
First row = recorder IDs 0-9, second row = recorder IDs 10-19, etc.
Green blocks indicate an allowed permission, and white blocks indicate that permission is
denied.
2. Double-click on a specific recorder to invert or alternate between permit or
deny
Be sure to click the save button (the picture of the floppy disk) before exiting
the Recorder tab to ensure the changes will be saved correctly.
Configuration
83