Changing Basic (System) Settings; Sfb I/O (Ip Address Network- And I/O-Settings) - Honeywell enCore Series Manual

8

8.2 Changing basic (system) settings

The following section explains some SFB of the basic system and how to adjust
their settings. An overview is given in the online help. Select Basic system in the
parameter tree of the parameterization window and press [F1].
8.2.1 SFB I/O (IP address network- and I/O-
settings)
The IP address and the input and output channels are part of the parameter set ex-
isting in the device. After reading out the parameterization
zation (p. 182), you can change the settings (offline) on the following page:
NOTICE
Do not change the network settings without consulting the IT
administration
Note all changes and show them on the device or its documents!
Change or activate the following I/O interfaces (the parameters open after clicking
the folder) for communication and data exchange with other devices.
Refer to the information in the online help which contains more
details required to define all the parameters for the following
settings.
GasLab Q2
Configuration and analysis software enSuite
Fig. 8-14: I/O Settings in enSuite
User Manual (N )
Read-out parameteri-
➪
190 of 315