Gaslab Q2 Operation Panel And Operation - Honeywell enCore Series Manual

7 GasLab Q2 operation panel and operation

GasLab Q2 will begin its starting procedure after the power supply has been con-
nected and it has been switched on. The interactive HMI, the screen and the LEDs,
are activated. This combination is also called operation panel.
In this start display, GasLab Q2 always displays current measured values for partly
saturated gas.
Process-dependent values (e.g. temperature, pressure, etc.) are initially displayed in
red (as a fault). When the operating conditions are reached and the status is error-
free, the display color changes to black. Both LEDs above the screen light up per-
manently in this case.
No further changes or operations are required for normal analysis operation. Only,
some functions and operating modes (known as operations) do require the use of
other displays, or the use of the enSuite configuration and analysis software.
Two access options enable device operation:
Access options
1. via the operation panel local on the device (described in this section)
via a PC or laptop described in section
2.
(p. 171)
The device has a user management system protected by a password to protect
important settings and simplify the parameterization process. For each type of ac-
cess applies:
There are no passwords when the device is supplied!
l
Passwords can be created and edited on the device.
l
Only one user can be logged in at any one time.
l
Logins, logouts and password changes are entered into the device's logbook.
l
Changes which have been completed but not yet saved are discarded when
l
you log out.
Honeywell can provide classes and training to make the measuring
equipment easier for you to use and for using all the individual options
offered by the device. If you are interested, please contact
nical support Flow Computers and Gas analyzers
GasLab Q2
8 Configuration and analysis software enSuite
➪
User Manual (N )
12.1 Tech-
➪
(p. 293)
104 of 315