Error Transferring The Data Record - Siemens SIMATIC ET 200eco PN M12-L Equipment Manual

B.3

Error transferring the data record

Error transferring the data record
The I/O device checks the values of the transferred data record. Only if the values were
transferred without errors does the I/O device apply the values from the data record.
The "WRREC" instruction for writing data records returns corresponding error codes in the
"STATUS" parameter when errors occur. For STEP 7 you will also find the parameter
description in the STEP 7 online help.
The Error codes table shows the following:
• The specific error codes of the I/O device
• The meaning of the error code
• A suggestion for correcting the error
• The data record at which the error may occur
Table B-1 Error codes
Error code in STATUS parameter
(hexadecimal)
Byte 0 Byte 1 Byte 2 Byte 3
DF 80 B0
DF 80 B1
DF 80 B2
DF 80 E0
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
I/O device digital outputs DQ 8x24VDC/0.5A M12-L 8xM12 (6ES7142-6BG00-0BB0)
Equipment Manual, 03/2023, A5E46570894-AD
Meaning
xx Number of the data record unknown.
xx Length of the data record incorrect.
xx I/O device cannot be accessed:
xx Wrong version or error in the header
information.
01 Reserved bit set
02 Invalid diagnostics enable bit set for
operating mode.
06 Invalid coding for substitute value reac­
tion.
11 Invalid output range set.
Parameter data record
B.3 Error transferring the data record
Solution
Enter a valid number for the data
record.
Enter a valid value for the data record
length.
Check the assigned values for the para­
meters of the "WRREC" instruction.
Correct the version, length and number
of parameter blocks.
Check the parameters of the I/O device.
Check the parameters of the I/O device.
Check the parameters of the I/O device.
Check the parameters of the I/O device.
DS128
✓
✓
✓
✓
✓
✓
✓
✓
67