Power Button/Led Board - HP ProLiant BL45p Maintenance And Service Manual

Power button/LED board

To remove the component:
Power down the server blade (on page 28).
1.
Remove the server blade (on page 28).
2.
Remove the secondary access panel
3.
Remove the processor air baffle
4.
Remove the fan assembly
5.
Remove all DIMMs ("DIMMs" on page 35).
6.
Remove the FC mezzanine, if installed
7.
Remove the NIC mezzanine, if installed
8.
Remove the I/O signal board
9.
Disconnect all cables connected to the system board
10.
Disengage the power connector from the chassis. Retain the thumbscrews for future use.
11.
Remove the secondary system board
12.
All manuals and user guides at all-guides.com
("Secondary access
("Processor air
("Fan assembly" on page 33).
("Fibre Channel
("NIC
("I/O signal board" on page 37).
("Secondary system
panel" on page 29).
baffle" on page 32).
mezzanine" on page 36).
mezzanine" on page 36).
("System board components" on page 75).
board" on page 49).
Removal and replacement procedures 62