Icom IC-905 Advanced Manual page 189

12
ABOUT THE DV GATEWAY FUNCTION
Access Point mode operation
D Making a Gateway call through the Access Point transceiver
When not using the DR function
In this document, the ID-51A (PLUS2)/ID-51E (PLUS2) is used as an example of a Remote D-STAR transceiver�
Step 1. Enter the VFO mode
Push [V/MHz]�
Step 2. Set the operating frequency
Rotate [DIAL] to set the frequency that is set in the
Access Point transceiver� (Example: 430�850)
Step 3. Set the Receive mode to "DV mode"
Push [MODE] several times until "DV" is displayed�
L When the "GPS TX Mode" is set, "DV-G" or "DV-A" is
displayed�
Step 4. Set the duplex direction
1� Push [QUICK]�
2� Select "DUP�"
3� Select "DUP–�"
12-20