Icom IC-905 Advanced Manual page 116

9
GPS OPERATION (ADVANCED)
GPS SET
» GPS > GPS Alarm
Alarm Area (RX/Memory)
Selects the GPS active alarm range.
When a target enters the active alarm range, the GPS
Alarm sounds, and the GPS alarm icon blinks.
L When "Alarm Select" is set to "RX" or "Memory," this
setting is enabled. (p. 9-38)
• Limited: The transceiver sounds 3 beeps, and the
GPS Alarm icon blinks when the target
enters the 500 meters range.
• Extended: The transceiver sounds 3 beeps, and the
GPS Alarm icon blinks when the target
enters the 1 kilometer range.
• Both: The transceiver sounds a beep, and the
GPS Alarm icon blinks when the target
enters the 1 kilometer range, and sounds
3 beeps, and the icon blinks when it
enters the 500 meters range. When the
target exits the 500 meters range, but
is still in the 1 kilometer range, the icon
continues to blink, but no beeps sound.
Example:
When a target station enters the active alarm range
(500 meters or 1 kilometer range, depending on the
setting), the GPS Alarm sounds and the GPS Alarm
icon blinks.
approximately 1 km, 1094 Y
approximately 500 m, 547 Y
Your location
Target
station
Sounds a beep�
(Default: Both)
Extended range
Limited range
Sounds 3 beeps�
» GPS
GPS Auto TX
Selects an option for the GPS automatic transmission
function. This function automatically transmits the
current position data received from a GPS receiver, as
well as any entered GPS message, at the set interval.
NOTE: When "GPS TX Mode" is "NMEA," set
"Position Input" to "Internal GPS." If you set to
"Manual," this function is not activated..
• OFF: Does not automatically transmit the position
data. (When you push [PTT], the transceiver
transmits the position data.)
• 30 sec to 30 min:
Transmits the current position data at the
selected interval (30 seconds, or 1, 3, 5, 10,
or 30 minutes).
N
9-39
(Default: OFF)