Getting Started; Supplying Power To The Wap; Connecting To The Wap; Figure 5. Ceiling Mounting The Netvanta 150 (Side View) - ADTRAN NetVanta 100 Series Hardware Installation Manual

Unit Installation
Side View
Bracket Detail

Figure 5. Ceiling Mounting the NetVanta 150 (Side View)

Getting Started

The 10/100Base-T Ethernet interface (ETH 0/1) MUST NOT be metallically connected to
interfaces that connect to the outside plant (OSP) or its wiring. This interface is designed
for use as an intrabuilding interface only. The addition of primary protectors is not
sufficient protection to connect this interface metallically to OSP wiring.

Supplying Power to the WAP

The NetVanta 150 WAP can be powered either by connecting the ETH 0/1 Power over Ethernet (PoE)
connector to a PoE-capable NetVanta controlling unit or connecting the 12 VDC external power supply to
the POWER connection. Both of these connectors are on the rear of the unit (see the
The external power supply is not automatically shipped with the NetVanta 150 WAP but a domestic
(P/N 4700412E1) or international (P/N 4700412E1#IN) bundle containing the appropriate external power
supply can be requested from ADTRAN or your reseller.

Connecting to the WAP

Using the provided Ethernet cable, connect the
Ethernet port of the NetVanta controlling unit or to an Ethernet port on a unit that can be accessed by the
controlling unit.
24
NetVanta 100 Series Hardware Installation Guide
1 1
ETH 0/1 port on the back of the NetVanta 150 WAP to the
Copyright © 2010 ADTRAN, Inc.
Ceiling Tile
2
Figure 2 on page
61700412E1-34C
20).