NetVanta 100 Series Hardware Installation Guide
3.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as wall
mounting and supplying power to the unit.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Maximum recommended ambient operating temperature is 50
Installing the Antennas
The NetVanta 150 WAP ships with two dual-band RP-SMA detachable antennas. These should be installed
before mounting or operating the unit.
Step
1
Place either of the two antennas directly onto the antenna port on the rear panel labeled
Antenna 1. See
2
Twist the antenna onto the threads until it is secure.
3
Repeat Step 2 with the second antenna, attaching it to the Antenna 2 port.
4
Once both antennas are secured, the antennas can be flexed at the joint to improve
performance.
Mounting Options
The NetVanta 150 WAP can be installed in a tabletop, wall mounted, or ceiling mounted configuration. If
the WAP is used in a tabletop configuration, proceed to
61700412E1-34C
Instructions for Attaching the Antennas
Figure 2 on page 20
to locate the antenna ports on the rear panel.
Copyright © 2010 ADTRAN, Inc.
°
Action
Getting Started on page
Unit Installation
C.
24.
21