Unit Installation
Wall Mounting
The NetVanta 150 can be safely mounted on the wall by following these steps:
Step
1
Install the antennas on the WAP. Refer to
2
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below
eye level so that the LEDs are viewable.
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not
provide sufficient long-term stability.
4
Install two #8 PAN-head wood screws (1-inch or greater in length) into the mounted board,
following these guidelines and referring to
•
Screws should be spaced horizontally, approximately 4 inches apart.
•
Screws should be horizontally leveled with each other.
•
Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of
the screws to slide into place in the unit's keyed insets.
5
Slide the keyed insets on the bottom of the unit's chassis securely onto the screws.
6
Proceed to the steps given in
22
Instructions for Wall Mounting
Installing the Antennas on page
Figure
Getting Started on page
Figure 3. Wall Mounting the NetVanta 150
Copyright © 2010 ADTRAN, Inc.
NetVanta 100 Series Hardware Installation Guide
Action
3:
24.
21.
61700412E1-34C