NetVanta 100 Series Hardware Installation Guide
Ceiling Mounting
The NetVanta 150 can be safely mounted on the ceiling by following these steps:
Step
1
Install the antennas on the WAP. Refer to
2
Using the mounting bracket (P/N 1700405G1) as a template, drill three holes in the ceiling tile
large enough for the #8-32 bolts.
3
Attach the mounting bracket to the ceiling tile using the provided #8-32 bolts, washers, and nuts
in the order shown in the Exploded View in
4
Insert the downward extending prongs of the mounting bracket into the keyholes on the bottom
of the unit as indicated by the Number 1 in the Side View in
5
Slide the unit backwards until the hook on the mounting bracket slides over the unit's plastic
casing, and the mounting bracket prongs are locked into the unit's keyholes as indicated by the
Number 2 in the Side View in
6
Attach all wires to the bracket using a wire tie through the hole located in the back of the hook
shown in the Bracket Detail in
7
Proceed to the steps given in
Exploded View
Figure 4. Ceiling Mounting the NetVanta 150 (Exploded View)
61700412E1-34C
Instructions for Ceiling Mounting
Action
Installing the Antennas on page
Figure 4
Figure 5 on page
24.
Figure 5 on page
Getting Started on page
Mounting Bracket
Copyright © 2010 ADTRAN, Inc.
below.
Figure 5 on page
24.
24.
Ceiling Tile
2
Unit Installation
21.
24.
23