Siemens SIMATIC V2 Operating Instructions Manual page 89

non-conductive dust environment and IP6X in accordance with GB 12476.1 & GB 12476.5
for Zone 22 conductive dust environment.
During use, make allowances for the ambient conditions.
• The equipment shall be installed in such a way that the risk of mechanical danger is low.
• To avoid an electrostatic charge, wipe the enclosure surface with a damp cloth only.
• When used in an area requiring the use of equipment with EPL Gc, the following
additional conditions apply:
– The equipment shall only be used in an area of not more than pollution degree 2, as
– Provisions shall be made to prevent the rated voltage from being exceeded by transient
FCC and Canada
USA
Federal Communications
Commission
Radio Frequency Interfer-
ence Statement
Shielded Cables
Modifications
Conditions of Operations
CANADA
Canadian Notice
Avis Canadien
Responsible party for Supplier's Declaration of Conformity in the USA
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
Mail to: (amps.automation@siemens.com)
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
defined in GB/T 16935.1.
disturbances of more than 119 V.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference received, includ-
ing interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003 (A).
Cet appareil numérique de la classe A est conforme à la norme NMB-
003 (A) du Canada.
Technical information
7.1 Certificates and approvals
89