Table of Contents
Advertisement
12.4.2 Cleaning the heat exchanger
Caution.
b
Risk of damage from water spray.
If you fail to protect the electronics box
adequately, water can penetrate the box
during cleaning and may damage the elec-
tronics.
> Protect the folded down electronics box
against sprayed water.
> Remove the compact thermal module (¬ section 12.4.1).
1
12.5 Cleaning the heat exchanger
Caution.
b
Risk of damage to the heat exchanger.
> You must neither loosen nor tighten the
four screws (1).
> Clean the heating coil (3) of the heat exchanger (4)
using water or, if required, commercially-available white
vinegar.
> Allow the vinegar to act on the heat exchanger for 20
minutes.
> Rinse away any loose dirt with a sharp jet of water or
use a plastic brush.
> Do not point the water jet directly at the insulating sur-
face (2) on the back of the heat exchanger.
The water flows out of the heat exchanger through the con-
densate siphon.
Installation and maintenance instructions ecoTEC plus 0020134833_01
Inspection and maintenance
12.4.3 Checking the burner
2
3
12.6 Checking the burner
As the burner (1) is maintenance-free, it does not require
cleaning.
> Check the surface of the burner for damage.
> If necessary, replace the burner.
4
12
1
65
Advertisement
Table of Contents
