Configure The Alarm Settings [Alarm Setup] - Panasonic WV-NP244 Operating Instructions Manual

Configure the alarm settings [Alarm setup]

The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, the alarm
occurrence notification, and the VMD area settings can be configured on this page.
The "Alarm setup" page has 3 tabs of the [Alarm] tab, the [VMD area] tab and the [Notification] tab.
Configure the settings relating to the alarm action [Alarm]
Click the [Alarm] tab on the "Alarm setup" page. (☞ page 16)
The settings relating to the alarm action can be configured on this page. Refer to pages 29 and 30 for further infor-
mation about the settings relating to the alarm image and the alarm out connector.
[Terminal alarm]
Select "ON" or "OFF" to determine whether or not to
receive the terminal alarm.
Default: OFF
[VMD alarm]
Select "ON" or "OFF" to determine whether or not to
perform the alarm action using the VMD function. Refer
to page 31 for descriptions of how to set the VMD
areas.
Default: OFF
[Command alarm]
Select "ON" or "OFF" to determine whether or not to
receive the command alarm.
The command alarm is the function that notifies of
Panasonic protocol alarm from the other cameras.
When "ON" is selected, alarm actions will be performed
between multiple cameras.
Default: OFF
28
[Originating port number]
Select a port number to be used to receive the com-
mand alarm.
Available port number: 1 - 65535
Default: 8181