Panasonic WV-NP244 Operating Instructions Manual page 23

Panasonic wv-np244: operating instruction
Hide thumbs Also See for WV-NP244:
Table of Contents

Advertisement

Configure the settings relating to MPEG-4 image [JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Camera setup" page. (☞ page 16)
Configure the settings such as "Refresh interval (MPEG-4)", "Image capture size" and "Image quality" on this page.
Refer to page 22 for further information about the settings relating to JPEG images.
[MPEG-4 transmission]
Select "ON" or "OFF" to determine whether or not to
transmit MPEG-4 images.
ON: Transmits MPEG-4 images.
OFF: Does not transmit MPEG-4 images.
Default: ON
Note:
When "ON" is selected for "MPEG-4" transmission,
displaying rather of MPEG-4 image or JPEG image
will be available. However, the refresh interval
(JPEG) may be longer than the set value when dis-
playing JPEG images.
[Max bit rate (per 1 client)*]
Select a MPEG-4 bit rate per a client from the following.
64 kbps/128 kbps */256 kbps */512 kbps */1024 kbps */
1536 kbps */2048 kbps */3072 kbps */4096 kbps *
Default: 2048 kbps *
Note:
The MPEG-4 bit rate is synchronized with "Total bit
rate" on the [Network] tab of "Network setup" page.
(☞ page 39)
For this reason, the bit rate may be lower than the
value when the setting value with an asterisk (*) on
the right is selected.
[Image capture size]
Select "QVGA" or "VGA" for the image capture size of
MPEG-4 images.
Default: VGA
[Image quality]
Select image quality of MPEG-4 images from the follow-
ing.
Fine/Normal/Low
Default: Normal
[Refresh interval (MPEG-4)]
Select an interval (1 - 5 seconds) to refresh the dis-
played MPEG-4 images.
If using under the network environment with frequent
error occurrences, shorten the refresh interval for
MPEG-4 to diminish image distortions. However, the
refresh interval (MPEG-4) may be longer than the set
value when displaying JPEG images.
Default: 3 sec
[Transmission type]
Select a MPEG-4 transmission type from the following.
Unicast: Up to 8 users can access a single camera
concurrently.
Multicast: No concurrent access limitation for a cam-
era.
Note:
Refer to page 4 for further information about the
maximum concurrent access number.
Default: Unicast
[Multicast address]
Enter the multicast IP address.
Images and audio will be transmitted to the designated
IP address.
Available address: 224.0.0.0 - 239.255.255.255
Default: 239.192.0.20
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wv-np240Wv-np240gWv-np244e

Table of Contents