Install The Intrusion Switch - Lenovo ThinkSystem SR655 V3 User Manual

2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Install the intrusion switch

Follow instructions in this section to install the intrusion switch.
About this task
Attention:
• Read "Installation Guidelines" on page 35
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
BashWCNZQEDP7o3EohXPEV
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the intrusion switch onto the fan cage.
Figure 49. Installing the intrusion switch
Note: Ensure that the intrusion switch cable is routed through the cable clip and the pre-cut slots
on the foam and fan cage bottom. Otherwise, the cable may slide under the fan cage, the contact
ThinkSystem SR655 V3 User Guide
78
and "Safety inspection checklist" on page 36
42.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
to ensure that you