Panasonic KX-TG5230 Operating Instructions Manual page 71

Problem
The handset and/or base unit
does not announce the
displayed caller's name.
The handset and/or base unit
does not announce the
displayed caller's name
properly.
The handset cannot
automatically edit the Caller
List/incoming phone numbers.
The handset display exits the
Caller List or phone book.
"Recharge battery" is
displayed, " " flashes,
3
or the handset beeps
intermittently.
"Charge for 6 HRS" and
" " are displayed and the
4
handset does not work.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash, or "Charge
for 6 HRS" and "
4
displayed.
The CHARGE indicator does
not go out after the battery has
been charged.
The Ringer/Message Alert
indicator flashes slowly when
the handset is not ringing and
in use.
For assistance, please call: 1-800-211-PANA(7262)
• The handset and/or base unit ringer volumes
are turned off. Set to high, medium, or low
(p. 18, 19).
• The Talking Caller ID feature is turned off.
Turn it on (p. 28, 29).
• Name pronunciation may vary. Name
pronunciation quality is based on names
most commonly used in the United States.
• The handset and/or base unit will announce
each letter of abbreviations, such as "Co."
and "Inc.".
• Caller ID supports names of up to 15 letters.
If the caller's name has more than 15 letters,
the name will not be announced correctly.
• The Caller ID Number Auto Edit feature is
turned off. Turn it on (p. 32) and try again.
• You need to press [C] or [s] after editing
the number.
• Do not pause for over 60 seconds while
searching.
• Fully charge the battery (p. 12).
• The battery has been discharged. Fully
charge the battery (p. 13).
• Clean the charge contacts and charge again
(p. 13).
" • The battery may need to be replaced. If you
3
install a new battery, fully charge it (p. 12, 13).
" are
• This is normal.
• The Message Alert is turned on and new
messages in your voice mailbox have been
recorded. Turn the Message Alert off (p. 21)
or listen to the new messages (p. 53).
Troubleshooting
Cause & Remedy
71