Using The Base Unit - Panasonic KX-TG5100M Operating Instructions Manual

Making Calls
To put a call on hold
Press [HOLD] (CLEAR) twice while talking.
• " " is displayed.
Hold
• To transfer the call to another extension, see page 42; to transfer to a mailbox to
allow the outside party to leave a message, see page 57.
To release the hold, press [
• The base unit user can also release the hold by pressing [DIGITAL SP-PHONE].
• Another handset user can also release the hold by pressing [
• If another phone is connected on the same line (p. 11), you can also release the
hold by lifting its handset.
• If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4
additional minutes on hold the call will be disconnected.

Using the Base Unit

1
Press [DIGITAL SP-PHONE].
• The indicator lights and "SP-phone"
is displayed.
2
Dial a phone number.
• The dialed number is displayed.
• After a few seconds, the display will
show the length of the call.
• If you misdial, press [DIGITAL SP-
PHONE] and start again from step 1.
3
When the other party answers, talk
into the MIC (microphone).
4
To hang up, press [DIGITAL SP-
PHONE].
• The indicator goes out.
• To switch to the handset while using the base unit speakerphone:
– If the handset is off the base unit, press [
[DIGITAL SP-PHONE] on the base unit.
– If the handset is on the base unit, just lift up.
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Talk alternately with the caller in a quiet room.
• If you or the other party has difficulty hearing, press [ ] to decrease the
speaker volume.
26
] or [ ].
Base Unit
] or [
] or [
[PAUSE/REDIAL]
[STOP]
[HOLD]
[ERASE]
[DIGITAL SP-PHONE]
and Indicator
] on the handset, then press
].
[ ], [ ]
MIC