IBM ED-X10 User Manual page 48

OPTION Menu
OPTION Menu (continued)
Item
SECURITY
48
4. Using the Transition Detector Function
While the Transition Detector function is ON, when power switch is started to
supply to the projector, it might react as below.
• Transition Detector alarm shown below might appear on screen, if the
projector has been moved or re-installed.
• Transition Detector alarm might appear on screen, if the MIRROR setting
has been changed.
• Keystone adjustment feature has been prohibited as long as the Transition
Detector function is ON.
4.1 Turning On the
4.- Use the ▲/▼ buttons on the SECURITY menu to
select Transition Detector and press the ► or the
ENTER button to display the Transition Detector
on/off menu. Select TURN ON and the current
angle, mirror and keystone setting will be recorded.
NOTE: This feature may not function properly if the projector
is not in a stable position when TURN ON is selected.
4.- If this function is set to TURN ON when
the vertical angle of the projector, mirror or
keystone setting at which the projector is
turned on is different than the previously
recorded the Transition Detector Alarm will be
displayed and the projector will not display the
input signal.
Either set the Transition Detector off in the SECURITY menu or set the projector at
the recorded angle, mirror and keystone setting to display the input signal.
If the Transition Detector ALARM is displayed for about 5 minutes the lamp will turn off.
This function will activate only when the projector is started after the power
switch was turned off.
4.2 Setting the Transition Detector
4.- Use the ▲/▼ buttons on the SECURITY menu to select Transition
Detector and press the ► or the ENTER button to display the Transition
Detector on/off menu.
4.- Use the ▲/▼ buttons on the Transition Detector
on/off menu to select TURN ON. The ENTER
PASSWORD BOX (small) will be displayed.
4.-3 Use the ▲/▼/◄/► buttons to enter a PASSWORD.
Move the cursor to the right side of the ENTER
PASSWORD BOX (small) and press the ► button
to display the CHECK PASSWORD BOX, enter the
same PASSWORD again.
4.-4 Move the cursor to the right side of the CHECK
PASSWORD BOX and press the ► button to
display the PASSWORD for about 0 seconds,
please make note of the PASSWORD during
this time. After the PASSWORD has displayed
for about 0 seconds the screen will return to
the Transition Detector on/off menu.
Pressing the ENTER button on the remote controll or the INPUT button on
the projector will close the PASSWORD BOX.
NOTE : Please do not forget your Transition Detector PASSWORD.
Description
Transition Detector
Function
Transition Detector
on/off menu
Transition Detector Alarm
PASSWORD
ENTER PASSWORD
BOX (small)
CHECK PASSWORD
BOX
PASSWORD BOX