Electrical Connections; Water Supply And Drain Connections - Hoshizaki IM-220AB Instruction Manual

ENGLISH
Mounting Bracket
Hex Head Bolt
w/Washers

6. ELECTRICAL CONNECTIONS

This icemaker requires an earth that meets the national and local electrical code requirements.
To prevent possible severe electrical shock to individuals or extensive damage to the unit, install a proper earth wire to the icemaker.
Disconnect the main power supply before any maintenance, repairs or cleaning is undertaken.
* This appliance requires a separate 220 - 240VAC, 10A supply. The electrical supply must be protected by a suitable circuit
breaker.
* Icemakers installed side by side should each have a separate receptacle, but they must all be connected in parallel to the
same single phase supply or circuit with sufficient ampacity.
* The main control box fuse is rated at 5A and should only be replaced by a qualified service engineer.
* Usually an electrical permit and services of a licensed electrician are required.
* If the supply cord is damaged, it must be replaced by a replacement cord available from Hoshizaki Parts/Service Centres.

7. WATER SUPPLY AND DRAIN CONNECTIONS

* The connections to the mains water supply must be made in accordance with the countries' current requirements of the Water
Supply or Water Fittings Regulations.
* Water supply pressure should be minimum 0.07 MPa (0.7 bar) and maximum 0.78 MPa (8 bar). If the pressure exceeds 0.78
MPa (8 bar), use a proper pressure reducing valve. Do NOT throttle back the supply tap.
* A plumbing permit and services of a licensed plumber may be required in some areas.
* The icemaker drain is gravity flow, so ensure drain pipe has an adequate pitch or fall.
Drain Pipe Collar
Icemaker
Bin
WARNING
THIS APPLIANCE MUST BE EARTHED
WARNING
Connect to potable water supply only.
Packing
Drain Pan
14
Ice Chute
Unit Frame
Hex Head Bolt
w/Washers (accessory)
Nylon Tie
Mounting Frame
Bin Control Switch