Table of Contents
Advertisement
Safety Information
General Safety Summary
Read the following precautions carefully to avoid any personal injuries, or damage to
the instrument or products connected to it. Use the instrument only as specified.
Use only the power cord supplied for the instrument.
Ground the instrument. The instrument is grounded through the ground conductor of
the power cord. To avoid electric shock, always connect to grounded outlets. Make sure
the instrument is grounded correctly before connecting its input or output terminals.
Connect the signal wire correctly. To avoid damage, observe input polarity and
maximum voltage/current ratings at all times.
Observe all terminal ratings and signs on the instrument to avoid fire or electric shock.
Before connecting to the instrument, read the manual to understand the input/output
ratings.
Do not operate with suspected failures. If you suspect that the instrument is damaged,
contact the Teledyne LeCroy service department immediately.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.
Avoid touching exposed circuits or wires. Do not touch exposed contacts or
components when the power is on.
Do not operate without covers. Do not operate the instrument with covers or panels
removed.
Use only the fuse specified for the instrument.
Use proper over voltage protection.
Use anti-static protection. Operate in an anti-static protected area. Ground
measurement cable conductors before connecting to the instrument to discharge any
static electricity before connecting the cables to the instrument.
Observe ventilation requirements. Ensure good ventilation. Check the vent and fan
regularly to prevent overheating.
T3VNA User Manual III
Advertisement
Table of Contents
