Fisher & Paykel WODV330 User Manual page 39

Wall oven
Hide thumbs Also See for WODV330:
Table of Contents

Advertisement

Changing the oven light bulbs
The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a
very long life, but if you should need to replace one, use only a replacement bulb
purchased from your nearest Fisher & Paykel dealer and follow these steps:
1 Allow the oven to cool and then turn it off at the wall.
2 Take out the shelves and side racks (see 'Removing and replacing the sliding shelves
and side racks') and use a small flat-head screwdriver to twist and lift the retainer clip
at the top of the glass light cover while holding the glass to prevent it falling.
The clip pivots counter-clockwise (see the diagram).
3 Carefully lift the glass cover out of the lower support and pull out the faulty bulb.
4 Holding the replacement bulb in a soft cloth or tissue (touching the bulb will reduce
its life span), insert the new bulb.
5 Reposition the glass cover and twist the top clip back in place. The procedure is
the same for the light in the roof of the oven cavity.
Note: oven bulb replacement is not covered by your warranty.
Retainer clip
Sockets for
the pins
CARE AND CLEANING
Plate glass cover
Pins
Replacement bulb
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wosv330

Table of Contents