Taking Pictures Using Burst Mode; Vqt0V10 - Panasonic Lumix DMC-LS2 Operating Instructions Manual

Taking Pictures using
Burst Mode
1
SCN SCN
1 Press the burst mode button to
switch the burst mode setting.
: High speed
;
: Low speed
;
: Unlimited
;
No display: canceled
¢1 Depends on the memory size,
battery power, picture size and
quality (compression).
2 Take a picture.
• Hold down the shutter button fully to
activate the burst mode.
∫ Number of pictures recorded in burst
mode
Burst speed
(pictures/
second)
¢2
3
¢2
2
approx. 1.5
¢2 The burst speed is constant regardless
of the transfer speed of the card.
2
3
¢ 1
Number of recordable
pictures (pictures)
max. 3 max. 5
Depends on the
remaining capacity of the
built-in memory/card.
• The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
• In simple mode [
as follows. [ ] appears on the left of the
screen. (P83)
– [ ENLARGE]:
/Max. 3 pictures
– [ 4qk6q/10k15cm]/[
/Max. 5 pictures
• When the burst mode setting is set to
Unlimited
– You can take pictures until the capacity
of the built-in memory or the card is full.
– The burst speed will become slower
halfway. The burst speed of a
MultiMediaCard becomes even slower
than that of an SD Memory Card.
However, the exact timing of this
depends on the number of recordable
pictures and the card.
• The focus is fixed when the first picture is
taken.
• When the self-timer is used, the number
of recordable pictures in burst mode is
fixed to 3.
• Burst mode is not canceled when the
camera is switched off.
• When auto bracket and burst mode are
set simultaneously, auto bracket will be
performed.
• The exposure and the white balance vary
depending on the burst mode setting.
When burst mode is set to [
[ ], they are fixed to the values set for
the first picture.
When the burst speed is set to [
they are adjusted each time you take a
picture.
Advanced
], the settings become
E-MAIL]:
] or
],

VQT0V10

45