Kubota V1505-CR-TE5 Operator's Manual page 45

BReplacement of fuel filter cartridge
[V1505-CR-TE5]
1. Replace the fuel filter cartridge with a new one every
400 operating hours.
2. Apply fuel oil thinly over the gasket and tighten the
cartridge into position by hand-tightening only.
3. Finally, vent the air.
A Replace the fuel filter cartridge periodically to prevent
wear of the supply pump or the injector, due to dirt in
the fuel.
A The fuel filter cartridge and water separator should be
replaced earlier according to the fuel classification in
use.
BCleaning of water separator (Type 1)
[V1505-CR-TE5]
(See "Draining of water separator" in "EVERY 50
SERVICE HOURS" in "REGULAR CHECKS AND
MAINTENANCE WORK" section.)
EVERY 500 SERVICE HOURS
BChanging of engine oil
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 500 hours thereafter. When the annual
operating hours are below 500, replace the oil every
year.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier when
the oil is warm.
REGULAR CHECKS AND MAINTENANCE WORK
underneath the
[D1803-CR-E5, D1803-CR-TE5, D1803-CR-TIE5,
V2403-CR-E5, V2403-CR-TE5, V2403-CR-TE5-BG,
V2403-CR-TIE5]
(1) Oil drain plug
[V2607-CR-E5, V2607-CR-TE5, V2607-CR-TIE5,
V3307-CR-TE5, V3307-CR-TIE5]
(1) Oil drain plug
[V3800-CR-TE5, V3800-CR-TE5-BG]
(1) Oil drain plug
3. When letting out the oil, remove the filler plug too. With
the filler plug still in place, it would be difficult to
discharge the oil completely.
4. Add new engine oil up to the upper limit of the oil level
gauge. Be careful not to add oil above the upper limit
of the oil level gauge.
31