Kubota V1505-CR-TE5 Operator's Manual page 47

EVERY 500 SERVICE HOURS OR 1 YEAR
BReplacement of water separator filter
(Type 2)
1. Replace the water separator filter with a new one
every 500 hours or 1 year.
2. Remove the old water separator filter with a filter
wrench.
3. Apply a film of oil to the gasket for the new water
separator filter.
4. Screw in the water separator filter by hand. Because,
if you tighten the water separator filter with a wrench,
it will be tightened too much.
(1) Water separator filter
A Replace the water separator filter periodically to
prevent wear of the supply pump or the injector, due
to dirt in the fuel.
EVERY 500 SERVICE HOURS OR 2 YEARS
BReplacement of fan belt
[V1505-CR-TE5]
Consult your local KUBOTA Dealer for this service.
(See "Adjustment of fan belt tension" in "EVERY 100
SERVICE HOURS" in "REGULAR CHECKS AND
MAINTENANCE WORK" section.)
EVERY 800 SERVICE HOURS
BChecking of valve clearance
[V1505-CR-TE5]
Consult your local KUBOTA Dealer for this service.
EVERY 1000 SERVICE HOURS
BChecking of valve clearance
Consult your local KUBOTA Dealer for this service.
REGULAR CHECKS AND MAINTENANCE WORK
EVERY 1500 SERVICE HOURS
BChecking of injector tip
Consult your local KUBOTA Dealer for this service.
BChecking of EGR cooler
Consult your local KUBOTA Dealer for this service.
BChanging of oil separator element
To avoid personal injury:
A Be sure to stop the engine before
changing the oil separator element.
1. Remove the cover and take out the oil separator
element and gasket. Then wipe oil and grease off the
zone in question.
2. Fit a new oil separator element and gasket into
position.
[D1803-CR-E5, D1803-CR-TE5, D1803-CR-TIE5,
V2403-CR-E5, V2403-CR-TE5, V2403-CR-TE5-BG,
V2403-CR-TIE5]
(1) Oil separator
[V2607-CR-E5, V2607-CR-TE5, V2607-CR-TIE5,
V3307-CR-TE5, V3307-CR-TIE5]
(1) Oil separator
33