Kubota V1505-CR-TE5 Operator's Manual page 44

30 REGULAR CHECKS AND MAINTENANCE WORK
[D1803-CR-E5, D1803-CR-TE5, D1803-CR-TIE5,
V2403-CR-E5, V2403-CR-TE5, V2403-CR-TE5-BG,
V2403-CR-TIE5]
(1) Fan belt
(2) Bolt and nut
[V2607-CR-E5, V2607-CR-TE5, V2607-CR-TIE5,
V3307-CR-TE5, V3307-CR-TIE5]
(1) Fan belt
(2) Bolt and nut
[V3800-CR-TE5, V3800-CR-TE5-BG]
(1) Fan belt
(2) Bolt and nut
BChecking of intake air line
Visually check for cracks, gas leak and anything else
unusual.
Check to see if the lock bolts and nuts are tight enough.
EVERY 400 SERVICE HOURS
BReplacement of oil filter cartridge
[V1505-CR-TE5]
To avoid personal injury:
A Be sure to stop the engine before
changing the oil filter cartridge.
A Allow engine
sufficiently, oil can be hot and cause
burns.
1. Replace the oil filter cartridge. Oil filter cartridge
should be replaced after the initial 50 hours of
operation and every 400 hours thereafter.
2. Remove the old oil filter cartridge with a filter wrench.
3. Apply a film of oil to the gasket for the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge enough
by hand. Because, if you tighten the cartridge with a
wrench, it will be tightened too much.
(1) Oil filter cartridge
5. After the new cartridge has been replaced, the engine
oil level normally decreases a little. Thus, run the
engine for a while and check for oil leaks through the
seal before checking the engine oil level. Add oil if
necessary.
A Wipe off any oil sticking to the machine completely.
to cool down