Kubota V1505-CR-TE5 Operator's Manual page 34

20 MAINTENANCE
[V3800-CR-TE5-BG]
(1) Oil filler plug
(2) Oil level gauge
4. If the oil level is too low, remove the oil filler plug, and
add new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes some time for the oil to drain
down to the oil pan.
Models
V1505-CR-TE5
D1803-CR-E5
D1803-CR-TE5
D1803-CR-TIE5
V2403-CR-E5
V2403-CR-TE5
V2403-CR-TE5-BG
V2403-CR-TIE5
V2607-CR-E5
V2607-CR-TE5
V2607-CR-TIE5
V3307-CR-TE5
V3307-CR-TIE5
V3800-CR-TE5
V3800-CR-TE5-BG
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
Engine oil quantity
6.7 L
(1.77 U.S.gals.)
7.0 L
(1.85 U.S.gals.)
9.5 L
(2.51 U.S.gals.)
10.2 L
(2.69 U.S.gals.)
11.2 L
(2.95 U.S.gals.)
13.2 L
(3.49 U.S.gals.)
A Engine oil should be API classification CJ-4 or CK-
4.
A Change the type of engine oil according to the
ambient temperature.
Above 25 C (77 F) 10W-30 or 10W-40 or 15W-40
-10 C to 25 C
10W-30 or 10W-40 or 15W-40
(14 F to 77 F)
Below -10 C (14 F) 10W-30 or 10W-40
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before adding
the new engine oil.
A Use of the following oil not only disallows the engine
from performing well in low temperatures until it
warms up sufficiently but may also lead to excessive
engine wear or engine seizure.
A Oil with a viscosity higher than 10W-30
A Oil not recommended by KUBOTA
A On DPF-equipped engines, part of the fuel may get
mixed with engine oil during the regenerating process.
This may dilute the oil and increase its quantity. If the
oil rises above the oil level gauge upper limit, it means
the oil has been diluted too much, resulting in a
trouble. In such case, immediately change the oil for
new one.
A If the interval of DPF regeneration becomes 5
hours or less, be sure to change the oil for new
one.
A Be sure to inspect the engine, locating it on a level
place. If placed on gradients accurately, oil quantity
may not be measured.