Omron V330-F Series Quick Start Manual page 27

3
Check that the controller is in a
Monitor state by the Monitor and
Stop Monitoring Buttons in the
Sysmac Studio toolbar.
The controller is in a Monitor
state if the Monitor Button is
selected (not selectable) and the
Stop Monitoring Button is
selectable, as shown in the
figure on the right.
* If the controller is in a Stop
Monitoring state, select
Monitor from the Controller
Menu in the Sysmac Studio.
4
Select Watch Tab Page from the
View Menu.
5
The Watch window Tab Page is
displayed under the Edit Pane.
6
Confirm that the variables shown
in the figure on the right are
listed in the Name column.
* If any of the required variables
are not listed, click Input Name
and add them.
* In the following description,
"Program0" of the variable
names in the Name column is
omitted.
Monitor
Stop Monitoring
Program execution status Receive data Send data
7. Connection Procedure
Start of input
Error codes
TCP
connection
status
24