Download Print this page

Stihl MSA 300.0 Instruction Manual page 60

Hide thumbs Also See for MSA 300.0:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 36
English
Fault
LEDs on the
battery
Saw cuts out
3 LEDs light
during operation.
up red.
Chainsaw run‐
time is too short.
Smell of smoke
or burning in the
cutting area.
"SAW CHAIN
LUBRICANT"
LED lights up in
red.
"SAW CHAIN
LUBRICANT"
LED flashes red.
STIHL connected
app is unable to
find the battery
with
.
60
Cause
Chainsaw is too hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
The saw chain has
not been correctly
sharpened.
Insufficient saw chain
oil in the oil tank.
The chain lubrication
system is supplying
insufficient saw chain
oil.
The saw chain is
over-tensioned.
The chainsaw is not
being used properly.
Insufficient saw chain
oil in the oil tank.
Insufficient saw chain
oil in the oil sensor.
The saw chain oil is
unsuitable, polluted or
too old.
The saw chain oil sen‐
sor is defective.
®
Bluetooth
radio inter‐
face on the battery or
mobile device is deac‐
tivated.
Excessive distance
between battery and
mobile device.
Remedy
► Engage chain brake and remove battery.
► Allow the chainsaw to cool down.
► Engage the chain brake, remove and refit
the battery.
► Switch on the chainsaw.
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Replace battery.
► Sharpen chain as specified.
► Fill up with saw chain oil.
► Increase oil feed rate.
► Clean the guide bar and saw chain.
► Tension the saw chain as specified.
► Have correct use explained, then prac‐
tice.
► Fill up with saw chain oil.
► Set the oil feed rate to maximum output
quantity.
► Set the power level to maximum perfor‐
mance.
► Switch on the chainsaw and leave to run
for about 1 minute.
The "SAW CHAIN OIL" LED extingui‐
shes. The oil pump can be adjusted for
work.
► If the "SAW CHAIN OIL" LED continues
to light up in red: Do not use your chain‐
saw and contact your STIHL authorized
dealer for assistance.
► Fill in and use new saw chain oil,
► If the "SAW CHAIN OIL" LED continues
to light up in red: Do not use your chain‐
saw and contact your STIHL authorized
dealer for assistance.
► Do not use the chainsaw and contact
your STIHL authorized dealer.
► Activate Bluetooth
®
battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer for assistance.
20 Troubleshooting
8.3.
radio interface on the
21.4.
0458-009-9602-A

Advertisement

loading

This manual is also suitable for:

Msa 300.0 c