JVC HR-S7600AM Instructions Manual page 45

STOP/EJECT
TIMER S-VHS ET
STANDBY/ ON
TV PROG
S-VIDEO (S-2) VIDEO (MONO) L —AUDIO— R
SYNCHRO EDIT
C.RESET
Downloaded from: https://www.usersmanualguide.com/
PLAY
PAUSE
INSERT A.DUB
SP/LP/EP COLOUR SYSTEM REC
1 2 3
2
4 5 6
7 8 9
0
4
1
EN GAGE IN SERT EDITIN G
6
Press IN SERT .
● Your recorder enters the Insert-Pause mode. (" ", " "
● The TV screen changes from the still picture to the
REW FF
DIGITAL
TBC/NR
JOG
ST ART EDITIN G
SHUTTLE
7
Load the source cassette and play back the segment that
is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your recorder; Insert Editing
begins at this point.
● " " and " " are displayed on the front display panel.
EN D IN SERT EDITIN G
8
At counter "0:00:00", Insert Editing will stop automati-
cally while the tape continues running in the Play
mode. If you wish to stop Insert Editing before the
specified edit-out point, press C. RESET .
FO R AV IN SERT EDITIN G
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
... In step
(" " and " " blink and " " lights up on the front display panel.)
N O TES:
● Suitable leads can be obtained from your dealer.
● Insert editing is not possible with cassettes whose safety tab
has been removed.
● When insert editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
● In insert editing, the recording speed (SP/LP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
● A small portion of the recording which precedes an insert edit
may become erased.
● Insert Editing is also possible using the rear panel AUDIO/
VIDEO (or S VIDEO) IN connectors. When using these
connectors, make sure to select the correct input mode in step
2 .
● Insert Editing is not possible with an NTSC tape.
and " " light up on the front display panel.)
input source you are going to record.
6 above, after you press IN SERT , press A. D U B also.
45
EN