Error Mode - Haier GE GDF450P R0 Series Technical Service Manual

To Enter Error Mode
Wake up the control by opening and closing the
door for all models.
For Models with 1 or 2 Pads
Wake up the control. Press and hold the Start
pad with the door closed, then open the door for
3-seconds, close the door and release the Start
pad. The Clean or Heavy light will turn on.
For Models with 3 or More Pads
Wake up the control. Press and hold the
furthest most pad on the left and the Start pad
simultaneously for 5 seconds.
Door Status Check: On entry into Error Mode,
the control reports the door status for 10 seconds.
• All LED's are solidly illuminated, if the door is
detected as closed.
• All LED's are flashing, if the door is detected
as open.
Error Code Display Mode
After the door check, the control will enter a
mode to display any fault codes that are currently
detected by the control.

Error Mode

Start LED
Blinks
2
3
4
5
6
7
8
9
To Exit Error Mode
Models with 1 or 2 pads, power cycle the unit.
Models with 3 or more pads, press any key.
– 55 –
Fault Fault Description
Code
F153 Door latch failure.
F50 Temperature sensor
high.
F51 Temperature sensor
low.
F53 Fuse failure with
circulation pump on.
F56 Failure to drain.
F97 Absent heat source.
F112/ Key stuck.
F155
F99 Minimum wash
temperature not met.