Door Strike - Haier GE GDF450P R0 Series Technical Service Manual

Detergent Module Diagnosing
1. Remove power to dishwasher.
2. Remove toe kick panel.
3. Disconnect door harness.
4. Remove and separate the door.
5. The inner panel may be set into the
dishwasher and latched in the closed position.
6. Reapply power.
7. Place the dishwasher into Service Mode (see
Service Mode section in this service guide),
then activate the detergent test to check for
13.5 VDC to the detergent module. Service
Mode will provide a 15-second activation time.
Detergent Dispenser Removal
1. Remove power to the dishwasher.
2. Remove and separate the door.
3. Remove the EPS cover, double back tape
is used to secure and is reusable (when
reinstalling the EPS cover, UP must be
toward the top of the door).
4. Remove six 1/4-inch hex-head screws.
5. Mounting plate removes from inside the door.
6. The detergent module can now be removed
from the inner door panel.

Door Strike

The door strike is attached to the inner door panel.
Door Strike Removal
1. Remove and separate the door.
2. Remove the control console or control panel.
3. Remove the 1/4-inch screw holding the
strike and lift up to remove the door strike (a
Phillips-head screw will come with the service
part for easier installation).
– 54 –
Mounting Plate