Restore Factory Default Settings - AMT Datasouth Documax 6390 User Manual

Select the printing direction of the print head: unidirectional, bidirectional or Auto
PRINT DIR
selected via software.
Select "Normal" or "Letter" print quality.
QUALITY
Disable or enable the low noise function. When this function is on, print speed will
QUIET MODE
be reduced.
If this function is on, the printer will advance the paper one line automatically after
AUTO LF
receiving every carriage return instruction.
TEAR OFF Advances tractor paper to tear off position.
Specify the wait time between installing the cut sheet into the paper guide and
LOAD PAPER when it is fed into the printer. Choose to wait specify time or press LF/FF key to
feed paper.
EJECT DIR Specify paper eject direction when loading paper from front.
After selecting this function, the printer will switch different pins to print table line
PIN SWITCH
automatically.
After selecting this function, the printer will detect the paper edge automatically
PAPER EDGE after feeding paper and start to print from the position according to the left margin
setting.
After selecting this function, the printer will auto detect paper skew when feeding
SKEW DETECT cut sheet paper. If the slant degree is beyond the set parameter, the printer will
eject paper automatically.
BAUD RATE Specify the printer serial data transfer rate.
PARITY Specify the parity bit for serial data transfer.
DATA BITS Specify the serial data bits.
STOP BITS Specify the serial data transfer stop bit.
Specify the protocol of printer serial data transfer as software control (XON/XOFF)
PROTOCOL
or hardware control (DTR).
Select the broken pin. The printer will automatically replace it with other pin to
print.

Restore factory default settings

1.
Factory default settings can be restored using the Windows Driver
DEFAULT key.
Print current profiles before executing
factory default restoration. Restoring
default settings will reset all four USER
profiles to their original factory settings.
- 27 -