Oregon Scientific RMR966PA Instruction Manual page 18

Trouble
The projection LED does not go on when AC/DC
adapter is installed
The Nightlight does not turn on
The unit is reset when SNOOZE button is
pressed
Warning:
- For other cases not listed in the above, feel free to contact our help line
- Do not dissemble the unit. This will void the warranty
Possible Cause
Projection-On button is slid to the Off-position
(i) The AC/DC Adaptor is not installed
(ii) The light intensity of the environment is too high
and "Auto" mode is selected
Batteries are being discharged
18
Remedy
Slide the Projection-On button to the On-
position
(i) Make sure the AC/DC adapter is securely
plugged into the unit and connected to the
wall-socket
(ii) Reduce the light intensity in the
environment or simply select the "Light-
On' mode
(iii) Adjust the sensitivity of the light sensor
(refer to Section II --- Nightlight function)
Replace with new batteries