Advertisement
Table-stand
First, unlock the two panels by pressing the unlock button. Lay the
control panel on a flat surface. Then adjust the angle of the display
panel for best display and support.
HOW TO RESET THE UNIT
The RESET button allows you to return all settings to factory set
values. The button is required only when the unit is not operating
in a favorable way, such as in the rare case of a malfunction.
The RESET button is located at the back of the unit below the
battery compartment. Press the button with a blunt stylus to reset
all values to their default settings.
MAINTENANCE
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact
with water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive
materials.Abrasive cleaning agents may scratch the plastic
parts and corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust,
temperature, or humidity. Such treatment may result in
malfunction, a shorter electronic life span, damaged batteries,
or distorted parts.
4. Do not tamper with the unit's internal components. Doing so
will terminate the unit's warranty and may cause damage. The
unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may leak.
6. Read this instruction manual thoroughly before operating the
unit.
SPECIFICATIONS
• Temperature Measurement
Main unit
Indoor Temperature measurement
Proposed operating range
Temperature resolution
Remote Temperature measurement
Proposed operating range
Temperature resolution
Relative Humidity Measurement
Indoor relative humidity
measurement range
Resolution
Remote unit
Measuring range
Temperature resolution
RF Transmission Frequency
No. of Remote unit
RF Transmission Range
Temperature sensing cycle
• Relative Humidity Measurement
Remote relative humidity
measurement range
Resolution
• Barometric Pressure Measurement
Pressure measuring range
Pressure sampling cycle
• Moon Phase Functions
Moon Phase Scanner Range
• Radio Controlled Clock
- Maintime set and synchronized by Radio Signal from the U.S.
Atomic Clock
- User selectable 12 or 24h display with hh : mm ss
- Date Format : Month-Day
- 1-minute alarm
6
: -5.0°C to +50.0°C
(23.0°F to 122.0°F)
: 0.1°C (0.2°F)
: -5.0°C to +50.0°C
(23.0°F to 122.0°F)
: 0.1°C (0.2°F)
: 25% RH to 95% RH
: 1% RH
: -20.0°C to +60.0°C
(-4.0°F to 140.0°F)
: 0.1°C (0.2°F)
: 433 MHz
: up to 3 units
: Maximum 100 feet
: around 39 - 43 seconds
: 25%RH to 95%RH
: 1% RH
: 795 to 1050 mb/ hPa
(23.48 to 31.01 inHg)
: 15 minutes
: From 1990 to 2019
Advertisement
