Advertisement
HOW TO SET AND ACTIVATE
THE DAILY ALARM
When the daily alarm time is displayed, press and hold ALARM for
three seconds.
Enter the value for the hour digits by the UP or DOWN button.
Press ALARM to confirm and go to the minute digits. Enter the
value and press ALARM to confirm.
The alarm is automatically activated and [
To deactivate it, press ALARM once in the alarm display mode.
When the alarm is active, it will go off at the set time. The display
will light up for five seconds with the [
interruption, the alarm will go off for 1 minute.
To stop the alarm, press [ALARM], [MODE], [LIGHT], [
[
] or [ZONE] button.
HOW TO CHECK INDOOR AND OUTDOOR-
REMOTE TEMPERATURES & HUMIDITIES
To display indoor temperatures and humidities, press the
CHANNEL button until the [
To display outdoor-remote temperatures and humidities, press the
CHANNEL button to scroll through the readings from up to 3
remote sensors.
The temperature can be shown in Centigrade (°C) or Fahrenheit
(°F). The unit is selected on the °C / °F slide switch.
If the readings go above or below the specified range, the display
will show flashing "HHH" or "LLL".
CHANNEL SCAN FUNCTION
Press and hold CHANNEL button for 3 seconds to enter channel
scan function. The readings of each channel will be displayed
automatically, one by one, for 4 seconds. Press CHANNEL again to
stop the scan function.
NOTE ON REMOTE TEMPERATURE
& HUMIDITY
Once batteries are in place for the remote unit, it will start transmit-
ting samplings at 39-43-second intervals.
If no signals are received when the remote temperature and
humidity is selected, blanks will be displayed. Press and hold the
CHANNEL and MEMORY buttons together to enforce a search.
This is useful in synchronizing the transmission and reception of
the remote and main units.
If that fails, check if the remote unit is still in place. Make sure the
transmission is within range and path is clear of obstacles and
interference.
Repeat this procedure whenever you find discrepancies between
the reading shown on the main unit and the remote unit.
] will be displayed.
] icon flashing. Without
] indicator lights up.
NOTE ON °C AND °F
The outdoor temperature display on the main unit is dominated by
the selection on the °C/°F slide switch of the main unit. Whatever
the display unit of the remote sensor is, it will only apply to the
remote sensor. The temperature display on the main unit will be
automatically converted to the chosen one on the main unit.
MAXIMUM AND MINIMUM
TEMPERATURES & HUMIDITY
The maximum and minimum recorded temperatures and humidity
will be automatically stored in memory. To display them, press
MEMORY to toggle among the maximum, minimum and current
temperatures and humidity. The respective MAX or MIN indicator
],
will be displayed.
To clear the memory, hold down MEMORY for three seconds. The
maximum and minimum temperatures and humidity will be erased.
If you press MEMORY now, the maximum and minimum
temperatures and humidities will have the same values as the
current one until different readings are recorded.
TEMPERATURE AND HUMIDITY TREND
The temperature trend and humidity trend indicators show the
trend of collected readings. Three trends rising, steady and falling,
will be shown.
Arrow
indicator
Temperature
Trend
Arrow
indicator
Humidity
Trend
WEATHER FORECAST
BAR938HGA is capable of detecting barometric pressure changes,
and based on the data collected, can predict the weather for the
next 12 to 24 hours. The effective range covers an area of 18 to 30
miles.
sunny
partly cloudy
4
Rising
Steady
Rising
Steady
cloudy
rainy
Falling
Falling
snowy
Advertisement
