Adhesive Mounting - Honeywell Versatilis Signal Scout Installation And User Manual

Chapter 5 - Setting up the Honeywell Versatilis Signal Scout
22
Figure 5-3: Magnetic Adapter Mounting

Adhesive Mounting

Perform the below instructions for adhesive mounting on the target
structure:
Prerequisite: Remove oil, moisture, and dirt from the intended
mounting surface of the target structure on which the Signal Scout
will be mounted. If the dirt is strong, remove it with some plant
approved solvent.
ATTENTION: Use the adhesive mounting adapter preferably on
a flat surface. As there is a potential risk of falling down of the
Signal Scout if it is mounted on uneven, rough, or curved
surfaces, due to lack of sufficient bonding area.
1. Screw-in the adhesive mount adapter into the threaded hole
provided on the base of the Honeywell Versatilis Signal Scout.
2. Firmly hold the base of the Signal Scout using a spanner (of size
41mm), and tighten the adapter to the base using another
spanner (of size 32mm).
Ensure a Torque of 3.5 to 4 Nm is applied for tightening.
3. Remove the protective film from adhesive face of the adapter.