Magnetic Mounting - Honeywell Versatilis Signal Scout Installation And User Manual

Chapter 5 - Setting up the Honeywell Versatilis Signal Scout
2. On the new location, mount the Signal Scout with the required
adapter on the target structure using recommended mounting
bracket (see the mounting instructions below).
3. Calculate/Capture the GPS coordinates for the new location.
4. Pair the Signal Scout using Honeywell Versatilis Connect App,
and map the new set of GPS coordinates to the Signal Scout.

Magnetic Mounting

Perform the below instructions for magnetic mounting on the target
structure:
ATTENTION: Do not use bare hands while installation as the
magnet is powerful and can pinch the skin/ fingers if not
handled properly.
1. Screw-in the magnetic mount adapter into the threaded hole
provided on the base of the Honeywell Versatilis Signal Scout.
2. Firmly hold the base of the Signal Scout using a spanner (of size
41mm), and tighten the adapter to the base using another
spanner (of size 32mm).
Ensure a Torque of 3.5 to 4 Nm is applied for tightening.
3. Attach the Signal Scout fitted with a magnetic mount adapter
onto the target structure (like beams, structure, frames, pipes, and
etc) with the help of magnetic pull force.
21