Back to Contents Page
MXM-Assembly Fan (Optional)
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the MXM-Assembly Fan
Replacing the MXM-Assembly Fan
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
Removing the MXM-Assembly Fan
1. Follow the instructions in
2. Remove the back cover (see
3. Follow the instructions from
4. Remove the system-board shield (see
5. Disconnect the MXM-assembly fan cable from the connector (MXM FAN) on the system board.
6. Remove the two screws that secure the MXM-assembly fan to the hex nut screws.
7. Carefully peel the silver foil from the MXM-assembly heat sink.
8. Lift the MXM-assembly fan along with its cable away from the system board.
NOTE:
The appearance of the system board may vary based on your computer model.
1
MXM-assembly fan
3
MXM-assembly fan cable
Replacing the MXM-Assembly Fan
1. Follow the instructions in
2. Align the screw holes on the MXM-assembly fan with the screw holes screw holes on the hex nut screw.
3. Adhere the silver foil to the MXM-assembly heat sink.
4. Replace the two screws that secure the MXM-assembly fan to the system board.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Before You
Begin.
Removing the Back
Cover).
step 2
to
step 5
in
Removing the Front
Removing the System-Board
2
screws (2)
Before You
Begin.
UserManuals.info
Stand.
Shield).