Dell XPS L701X Service Manual page 32

Back to Contents Page
Coin-Cell Battery
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
manufacturer. Discard used batteries according to the manufacturer's instructions.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
Removing the Coin-Cell Battery
1. Record all the screens in system setup utility (see
2. Follow the instructions in
3. Remove the back cover (see
4. Follow the instructions from
5. Remove the system-board shield (see
6. Locate the battery socket (see
CAUTION:
object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by
prying off the socket or by breaking circuit traces on the system board.
7. Press the battery release lever to remove the battery.
1 battery release lever
Replacing the Coin-Cell Battery
1. Follow the instructions in
2. Insert the new battery (CR2032) into the socket with the side labeled "+" facing up, and press the battery into place.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
System Setup
Before You Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front
Removing the System-Board
System Board Components).
If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the
Before You Begin.
UserManuals.info
Utility) so that you can restore the correct settings in
Stand.
Shield).
step 7.