Powering Off The Projector; Warning Indicator - Optoma H27 User Manual

Installation

Powering Off the Projector

1. Press the "Power/Standby" button to turn off the projec-
tor lamp, you will see a message "Power off the lamp?
Picture Mute" displayed on the projector's screen. Press
the "Power/Standby" button again to confirm, otherwise
the message will disappear after 25 seconds.
Please note that if the
projector will enter the "Picture Mute" mode and no
image will be displayed. To exit the "Picture Mute" mode,
press the "Power/Standby"button again, or press "Hide"
on the remote control.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the Power LED will turn green.
When the Power LED begins flashing, the projector has
entered standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, simply
press "Power/Standby" button to restart the projector.
3. Disconnect the power cord from the electrical outlet and
the projector.
4. Do not turn on the projector immediately following a
power off procedure.

Warning Indicator

When the "LAMP" indicator lights solid red, the projector will
automatically shut itself down. Please contact your local reseller
or service center.
When the "TEMP" indicator lights solid red for about 20
seconds, it indicates the projector has been overheated. You
will see a message "Projector Overheated. Lamp will auto-
matically turn off soon." on the on-screen display. The
projector will automatically shut itself down.
Under normal conditions, the projector can be switched on again
after it has cooled down. If the problem persists, you should
contact your local dealer or our service center.
When the "TEMP" indicator flashs red for about 10 seconds,
you will see a message "Fan fail. Lamp will automatically turn
off soon." on the on-screen display. Please contact your local
dealer or our service center.
key is pressed instead, the
12