neighbor Terra In-line Half Table Assembly Instructions

Assembly Guide
TE RRA COLLECTION
In-line Half Table
Two sides connected
If attaching to Armless or Arm Modules:
Attach two Long Table Legs and two
1
Short Table Legs to Table Top.
8x 20mm Bolt, Spring, and Flat Washer
If attaching to Corner Module:
Attach two Long Table Legs and one
1
Short Table Leg to Table Top.
6x 20mm Bolt, Spring, and Flat Washer
Parts
Short Table Leg
1x
In-line Half
1x
Table Top Long Table Leg
2x
Hardware
20mm Hex Bolt Spring Washer
8x 8x
Have questions, comments, or feedback? Reach out at support@hineighbor.com Have questions, comments, or feedback? Reach out at support@hineighbor.com
Short Corner
1x
Table Leg
*Only needed if attaching
to Corner Module
Flat Washer Allen Wrench
8x 1x
Connect to previously assembled module
2
and adjust leveling feet as needed.
6x 20mm Bolt, Spring, and Flat Washer
May need to
remove Short and
Long Leg first.
Attach Short Corner Table Leg to Corner Module
2
first, then connect modules. Adjust leveling feet.
6x 20mm Bolt, Spring, and Flat Washer from Corner Module
Important
Replace any seating module legs with the included
table legs to match the height of the table.
Short Leg
Short
Table Leg
Note: there will be additional Table Legs in your box
that may or may not be needed for this configuration.
See other configuration option on opposite side.
• Do NOT use a drill while assembling
• Assemble all parts on a soft surface
May need to remove
Long Leg first.
Short Corner
Short
Table Leg
Corner Leg