Replacing The V-Belt; Checking The Brake Light Switches; Checking And Lubricating The Cables - Yamaha MBK XMAX 2014 Service Manual

2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Place a container under the final transmis-
sion.
4. Remove:
• Final transmission oil filler cap "1"
(along with the O-ring "2")
• Final transmission oil drain bolt 3"
(along with the gasket)
Completely drain the final transmission oil.
5. Install:
• Final transmission oil drain bolt
(along with the gasket
Final transmission oil drain bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
6. Fill:
• Final transmission oil
(with the specified amount of the recom-
mended final transmission oil)
Final transmission oil
Type
YAMALUBE 10W-40 or SAE
10W-30 type SE motor oil
Quantity
0.21 L (0.22 US qt, 0.18 Imp.qt)
7. Install:
• Final transmission oil filler cap "1"
(along with the O-ring)
1
2
3
New
)
PERIODIC MAINTENANCE
8. Start the engine, warm it up for several min-
utes, and then turn it off.
9. Check:
• Final transmission oil leakage
EAS1SD1011

REPLACING THE V-BELT

1. Remove:
• V-belt case
Refer to "V-BELT AUTOMATIC TRANSMIS-
SION" on page 5-30.
2. Check:
• V-belt
Cranks/damage/wear → Replace.
Grease/oil → Clean the primary and second-
ary pulleys.
Refer to "V-BELT AUTOMATIC TRANSMIS-
SION" on page 5-30.
TIP
Replace the V-belt every 18000 km (10500 mi)
of operation.
3. Install:
• V-belt case
Refer to "V-BELT AUTOMATIC TRANSMIS-
SION" on page 5-30.
4. Reset:
• V-belt replacement indicator
Refer to "INSTRUMENT FUNCTIONS" on
page 1-18.
EAS1SD1012

CHECKING THE BRAKE LIGHT SWITCHES

1. Check:
• Front brake light switch operation
• Rear brake light switch operation
When operating the brake levers, confirm
that the brake light comes on.
Faulty → Refer to "CHECKING THE
SWITCHES" on page 8-131.
EAS21690
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the in-
ner and outer cables.
EWA1SD1004
WARNING
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
• Outer cable
Damage → Replace.
3-23